此系统针对电动/混合动力汽车的车载充电器与DC/DC转换器的输入/输出特性、效率与保护项目测试。

优化后的标准测试项目(On-Board Charger):

可符合QC/T 895-2011法规标准
Charger Pre-setup (初始设定)

• Charger Input/Output Test (输入输出测试)
• Charger Line Regulation Test(输入效应测试)
• Charger Load Regulation Test(负载效应测试)
• Charger Hold On Adjust Test(在线调整测试)
• Charger Fin Ramp Shut Down Test(输入频率极限测试)
• Charger Fin Ramp Start Up Test(开机频率极限测试)
• DSO Setup For 4 Channels(数位式示波器设定/4 Channels)
• Charger Cursor Measure Time(光标量测时间)
• Charger Load Setup(负载设定)
• Charger Over Load Protection Test(过载保护测试)
• Charger OVP (CC Mode) Test(负载定电流模式下过电压测试)
• Charger OVP (CV Mode) Test(负载定电压模式下过电压测试)
• Charger Peak Current Test(峰值电流测试)
• Charger Ripple & Noise Test(涟波及杂讯测试)
• Charger Short Circuit Protection Test(输出短路保护测试)
• Charger Static Test(静态测试)
• Charger Vin Ramp Shut Down Test(输入电压极限测试)
• Charger Vin Start Up Test(开机输入电压极限测试)
• Charger Waveform Measure Test(波形量测)
• Charger Waveform Measure Turn On Test(开机波形量测)
• Charger Waveform Measure Turn Off Test(关机波形量测)
• Enable Turn On/Off Charger
• CAN Bus Reading Charger

优化后的标准测试项目(DC-DC Converter):

可符合GB/T 24347-2009法规测试
DD-System Pre-setup(系统初始设定)

• DC-DC Input/Output Test(输入输出及效率测试)
• DC-DC Line Regulation Test(输入效应测试)
• DC-DC Load Regulation Test(负载效应测试)
• DC-DC Hold On Adjust Test(在线调整测试)
• DSO Setup For 4 Channels(数位式示波器设定/4 Channels)
• DC-DC Cursor Measure Time(光标量测时间)
• DC-DC Over Load Protection Test(过载保护测试)
• DC-DC Over Voltage Protection Test(过电压保护测试)
• DC-DC Peak Current Test(峰值电流测试)
• DC-DC Ripple & Noise Test(涟波及杂讯测试)
• DC-DC Short Circuit Protection Test(短路保护测试)
• DC-DC Total Regulation Test(总效应测试)
• DC-DC Vin Ramp Shut Down Test(输入电压极限测试)
• DC-DC Vin Ramp Start Up Test(开机输入电压极限测试)
• DC-DC Waveform Measure Test波形量测)
• DC-DC Waveform Measure Turn On Test(开机波形量测)
• DC-DC Waveform Measure Turn Off Test(关机波形量测)
• Total Efficiency Test(总效率量测)
• Enable Turn On/Off DC-DC
• CAN Bus Reading Charger

CAN Bus Pre-Setup(初始讯息设定)